Lightning Arrestor for GPS Antenna
This lightning arrestor connects between antenna and GPS receiver. A surge protection device for securing transceiver against transients, over-voltage, and surge currents induced by bolts of lightning.
For the purpose of protecting the indoor equipment and circuitry connected to the LoRa gateway, you need to install an Ethernet port SPD lightning arrestor.
By adopting a high pass filter, this product can effectively suppress the low-frequency interference induced by lightning while letting through the GPS signal with low insertion loss. A transient suppression device (TVS) and a gas discharge tube (GDT) is adopted for the protection of the DC feed circuit.
Frequency Range: 1500MHz ~ 1650MHz
VSWR: ≤ 1.2
Insertion Loss: ≤ 0.3dB
RF Power: < 50W
DC Feed Voltage: 6V
DC Feed Current: 500mA
Ingress Protection: IP65
Surge Side Connector: N-type connector, Female
Protected Side Connector: N-type connector, Male
Grounding wire: 10AWG Yellow-green dual-color wire
Grounding connection: Pressed connection by N-type nut
Product Weight: Approximately 200g
Product Dimension: 89mm x 30mm
Questions and Answers
Have a Question?
Be the first to ask a question about this.
Similar Products in this Category