RAK5205 LoRa® Tracker Board
RAK5205 LoRa® Tracker Board
RAK5205 LoRa® Tracker Board
RAK5205 LoRa® Tracker Board
RAK5205 LoRa® Tracker Board
RAK5205 LoRa® Tracker Board

RAK5205 LoRa® Tracker Board

Regular price $49.50 $0.00
Shipping calculated at checkout.

Product Description

The RAK5205 LoRa® Tracker Board is built upon the RAK811. At its core is an STM32L1 microcontroller driving Semtech’s SX1276/78 LoRa® chip.

GPS is present as well as a number of sensors. The aforementioned makes the board suitable for rapid application development, such as asset tracking, vehicle management, location-based services, environmental monitoring, etc. Additionally, because of its low power consumption in sleep mode, it can provide a long-lasting solution for any battery-powered project.

The support for AT commands makes configuration a breeze. For advanced users is open source support in case a custom firmware is required.

Complete documentation of this product can be found on our website documentation page. 

Key Features

  • RAK811 (Semtech 1276/78 + STM32L1) at its core
  • Ublox Max 7Q GPS Module Built-in
  • Bosch BME680 Sensor (Temperature, Humidity, Air Pressure, Gas)
  • LIS3DH 3-axis Accelerometer
  • Works in Battery/Solar Power Mode
  • Sleep Mode consumption down to 14.6uA
  • Custom AT command Firmware
  • Full LoRaWAN 1.0.2 Stack Support
  • Interfaces Include I2C, UART, and ADC
  • 96Boards compatible form factor (30pin header)


  • Board Dimension: 60mm x 30mm x 11.45mm
  • Board Weight: Approximately 5.64 oz
  • Package Inclusions:
    • RAK5205 Board
    • GPS antenna
    • LoRa® antenna
    • Jumpers
    • DuPont Lines
    • Micro USB Cable

Questions and Answers

  • Hi, what sort of antenna does the IPEX variant come with?

    You can check the link below:

    This is for a gateway kit, however, the antennas should be the same as the ones shown in the first image.

  • Hello, The GPS for this device is giving a location which is 500 meters away from the real location. I tried in open field and lat/long reading is off by 500 meters Is there anyway to adjust this?

    For questions of this nature please ask in the forum.

  • Hello, I have 4 units of this working at 433MHz. I have issues with the GPS . After boot, GPS works fine but after that it reports GPS Signal not found. All 4 devices are acting on the same way [16:27:28:480] OTAA mode: [16:27:28:480] DevEui: 60C5A8FFFE760016 [16:27:28:480] AppEui: 00137A1000000000 [16:27:28:480] AppKey: 5A6967426565416C6C69616E63653039 [16:27:28:482] OTAA Join Start... [16:27:30:282] latitude: 14.489575, longitude: 121.006007 , altitude: 0 ; [16:27:33:664] OTAA Join Success! [16:27:33:673] latitude: 14.487805, longitude: 121.009286 , altitudeGps: 34m [16:27:37:516] Tx_Bat: 4166mv,speed: 0.370400km/h [16:27:41:359] Tx_ACC X:16mg Y:-16mg Z:-976mg [16:27:45:491] T: 33.55 degC, P: 1005.56 hPa, H 63.36 %rH , G: 18128 ohms [16:27:49:790] T: 33.70 degC, P: 1005.56 hPa, H 62.96 %rH , G: 22833 ohms [16:30:02:491] FAIL. GPS signal not found! [16:30:07:788] Tx_Bat: 4170mv,speed: 0.000000km/h [16:30:11:631] Tx_ACC X:16mg Y:-16mg Z:-976mg [16:30:15:763] T: 33.68 degC, P: 1005.56 hPa, H 64.55 %rH , G: 19297 ohms [16:30:20:063] T: 33.69 degC, P: 1005.58 hPa, H 64.05 %rH , G: 24413 ohms [16:32:32:763] FAIL. GPS signal not found! [16:32:36:979] Tx_Bat: 4166mv,speed: 0.000000km/h [16:32:40:822] Tx_ACC X:16mg Y:-16mg Z:-976mg [16:32:44:955] T: 33.65 degC, P: 1005.62 hPa, H 64.58 %rH , G: 20608 ohms [16:32:49:254] T: 33.65 degC, P: 1005.60 hPa, H 64.10 %rH , G: 26214 ohms

    What firmware version are you running?

Similar Products in this Category

Click to edit the product in Ali Orders.
Note: only show for shop owner